4-20mA Transmitter for dissolved oxygen sensors, DIN rail
- Order number: 35402
UMS Transmitter, DIN rail
Measuring amplifier for automation.
compatible with all... more
Product information "4-20mA Transmitter for dissolved oxygen sensors, DIN rail"
UMS Transmitter, DIN rail
Measuring amplifier for automation.
- compatible with all UMS DO sensors and DO sensors for ink
- Measuring ranges : oxygen in mg / l and %sat ( switchable )
- Fully automatic temperature compensation
- Automatic pressure compensation with integrated air pressure sensor for higher accuracy during calibration and to calculate the relative value (% saturation)
- Only 1 unit wide on the DIN rail
- 4 - 20 mA current loop
- 24 mA failure signal
- Power supply via current loop ( 2 wire / loop powered ) or separately ( 4 wire )
- Easy Calibration by pushbutton using the calibration chamber
- Synchronous sampling according to the mains frequency (50 and 60 Hz) increases immunity to interference. (Especially while using long sensor cable and parallel routing to power cables)
- Fault detection temperature sensor (short circuit or not connected)
- also available in waterproof case
- extended measuring range available on request
Two display LEDs:
1. Status LED : permanently indicates the selected measuring parameter. (% Sat or mg / l)
2. Error LED : indicates type of an error occurring
Operating manuals, software, drawings, sample programs and product flyers are available in the download area.
Measurment ranges | Accuracy |
0.0 .. 19.9 mg/l | 0.02 mg/l |
0.1 .. 199.9 %sat | 0.1 %sat |
Output current | 4 - 20 mA |
Failure signal | 24 mA |
Sampling rate | 1 Hz |
Supply voltage | 9 - 28 V DC |
Dimensions ( LxBxH ) | 90 x 17.9 x 59 |
Related links to "4-20mA Transmitter for dissolved oxygen sensors, DIN rail"
Viewed